To order ink for you printer Please call 1-877-453-3640 or online www.bestinsupplies.com

Canon BC-30 and BC-31 Cartridges

Also,

BCI-3BK, BCI-3C, BCI-3M, and BCI-3Y Cartridges
BCI-3eBK, BCI-3eC, BCI-3eM, and BCI-3eY Cartridges
BCI-5BK, BCI-5C, BCI-5M, and BCI-5Y Cartridges
BCI-6BK, BCI-6C, BCI-6M, and BCI-6Y Cartridges

Different Canon Printers

including:

Canon 3000, 6000, 8200
Canon S400, S450, S500, S600, S750, S800, S900
Canon i750, i800, i950
And many other Canon printers

Required Supplies and Tools

You will need the following:

A standard luer-type syringe (20 to 30 cc is best) . No needle is necessary.
A replacement Ball. These can be ordered from us.

Refill Instructions

Step 1) Put the cartridge on some paper towels in an area where you can tolerate a spill.

Step 2) Locate the ink exit hole and turn the cartridge so that this hole is facing up. Dribble some ink into this hole to fill the sponge area.

Step 3) When the sponge area is full, tape over the exit hole with black electrical tape.

Step 4) Locate the original fill hole under the black dot labeled "PUSH".

Step 5) Peel off the label and either remove the ball plug or push it into the cartridge. If this is a 2nd refill, we suggest removing the ball by jabbing a pin into the ball and prying it out. Otherwise, the accumulation of balls will gradually fill the cartridge.

Step 5A) Alternatively, you may make your own hole into this chamber by using a hot paper clip and melting a hole, or by drilling a hole. The important thing is not where you make the hole, but that there is a hole.

Step 5) Take your syringe. Fill the syringe with ink.

Step 6) Take the syringe and insert into the hole.

Step 7) Inject the cartridge with ink. Fill S-L-O-W-L-Y to fill the entire cartridge. Stop when the ink comes out of the ink exit hole.

The Black cartridges should require about 20 to 25 ml (cc) of ink. BCI-6 cartridges may require a bit more.
The color cartridges should require about 12 to 15 ml (cc) of ink. BCI-6 cartridges may require a bit more.

Step 8) Seal the hole with a new ball plug. Alternatively, you may use hot glue, hot wax, silicone rubber, or (if desperate) electrical tape. You need to get a good air-tight seal or you will develop a leak. You also need to get the seal flush with the surface.

Ordinary scotch tape will not give an airtight seal.

Step 6) Set over a paper towel for a few minutes as a drip precaution. Do not let the cartridge touch the paper towel, or the towel will draw the ink out of the cartridge. Expect a few drips -- the ink must drip for the sponge to be full. Cover all holes with electrical tape during storage to prevent leaks and evaporation.

To order ink for you printer Please call 1-877-453-3640 or online www.bestinsupplies.com